Jura WE8 Coffee Machine Message: Fill Bean Container
Fill bean container means the bean container is empty. No specialty coffees can be made, but hot water and milk can still be prepared. Fill the container and the message clears.
Low: an operator prompt, and hot water and milk stay available.
- Code
- Fill bean container
- Maker
- Jura Professional
- Equipment
- Super-automatic coffee
- Applies to
- WE8, JURA Type 737
What does Jura Professional Fill bean container mean?
The WE8 has a bean container, and the machine detects when it runs out of beans. Without beans there is nothing to grind, so specialty coffees are unavailable and the display shows Fill bean container. The manual says hot water and milk can still be prepared, so the machine is not stopped altogether. The action is to fill the bean container. This is an operator prompt, not a failure. It can return soon after filling when beans bridge above the grinder opening, or when the lid is not seated. Oily beans are the usual cause of sticking. Keeping the container topped up avoids losing specialty coffees mid-service. The instructions for the WE8 list 220-240 V, 50 Hz. The beans themselves matter too: very oily or flavored beans tend to cling to the walls of the container and stop flowing even when plenty remain. Check the level by looking into the container rather than trusting the last time it was filled, and use the lid so dust and moisture stay out of the grinder path.
Affected models and control systems
JURA WE8, JURA Type 737. Wording is taken from the WE8 instructions for use (Original instructions), which list 220-240 V, 50 Hz in the technical data.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- Fill bean container on the display
- Specialty coffees unavailable
- Hot water and milk still work
- Grinder runs but no beans arrive
Possible causes
Likely causes — what usually sits behind Fill bean container on this control. A technician confirms which one it is before any part is replaced.
- Bean container is empty
- Beans bridging above the grinder opening
- Oily beans sticking to the container walls
- Bean detection fouled with coffee oil
Safe checks before calling for service
- Fill the bean container with whole beans.
- Close the lid and seat the container properly.
- Tap the container lightly if beans seem stuck.
- Make a coffee and listen for the grinder.
- If the message remains, note it and tell the service technician.
How a technician diagnoses Fill bean container
- Confirm the message and the bean level.
- Check the bean flow to the grinder.
- Inspect the bean detection for oil and residue.
- Test the detection circuit with a meter.
- Verify specialty coffee can be made.
- The grinder and detection are inside the housing.
- Cleaning the grinder area needs panels removed.
- A meter is needed to test detection.
How Fill bean container differs from similar codes
The WE8 has one bean container. The GIGA X8 has two and names the side.
Technical reference
- Maker documentation
- Jura Professional owner support
- Edition
- No revision printed (technical data page lists 220-240 V, 50 Hz)
- Models / control
- WE8, JURA Type 737
- Section
- Chapter 6 Display messages (printed p. 36)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Jura Professional super-automatic coffee error codes
Can I make a latte?
Hot water and milk can still be prepared, but not espresso.
It stays after refilling.
Check that beans reach the grinder.
Which beans?
Whole beans, as the manual describes.
Need help with Jura Professional Fill bean container?
A technician confirms the cause on site and gives you the price in writing before any work starts.