Continental Girbau Inteli Washer Error Code 102: No Memory Available

What does Continental Girbau error code 102 mean?

The Inteli control stores programs in a memory of limited size. When someone enters or copies a program and the memory has no room left for it, the control shows 102 (No memory available). It is a programming message, not a sign that the control has failed. The manual's action is the same as for code 101: verify the program contents and delete unused programs. Code 101 says every program slot is taken, while 102 says the memory itself is out of room, which can happen even when slots remain, for example when programs are long. No individual causes are itemized for this code. The practical fix is housekeeping: review the stored programs, remove the ones nobody uses and shorten any that carry steps they do not need. Writing each program down before deleting it protects the site's settings, because a deleted program cannot be recovered from the washer.

Affected models and control systems

Continental Girbau E-Series washer-extractors with Inteli control, sheet names RMG055 and smaller and EH060 and larger. Washers with Logi, LogiPro or Vended control use ALn alarms instead.

Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.

What you may notice

• Code 102 on the display
• New program cannot be saved
• Programming stops when memory is filled

Possible causes

Likely causes — what usually sits behind error code 102 on this control. A technician confirms which one it is before any part is replaced.

• Program memory is full
• Long programs with many phases using up the space
• Old versions kept after changes
• Programs copied from another washer and never trimmed

Safe checks before calling for service

How a technician diagnoses error code 102

1. Confirm the code appears while saving a program.
2. List all stored programs and their lengths.
3. Back up the settings of any program to be removed.
4. Delete unused programs and phases.
5. Save the new program and run it to confirm.

How error code 102 differs from similar codes

Code 101 says all slots are used, 102 says memory is full, and 103 says a single program is full.

Technical reference

Document

Inteli Control Error Codes ST-102. R2 E-Series Inteli Control

Maker documentation

Continental Girbau owner support

Edition

7/17/2023

Models / control

E-Series washer-extractors with Inteli control (sheet names RMG055 and smaller, EH060 and larger)

Section

Alarm table, p.1-5

Checked

October 2026

We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.