Elmeco Slush Machine Error Code ALARM DATE: Date Setting

What does Elmeco ALARM DATE mean?

The Millennium board keeps a date, which it uses for its scheduled functions. If it finds a problem with that date setting, it raises an alarm. As with the other alarms, the board blinks and pressing MENU for one second shows ALARM DATE. The manual gives the meaning as a problem found by the electronic board with the date setting, and gives the same thing as the cause, a date setting problem found by the electronic board. The action is to disconnect the power cable first and then adjust the date with the programmer module. That means the correction is a setting change, not a repair of a part. The manual also notes that this alarm is not present on the First Class Millennium Basic, so a Basic board will never show it. The manual does not say how the date became wrong. A long power loss, a replaced board or a setting that was never entered are all possibilities, but those are our guesses.

Affected models and control systems

This applies to Fetco by Elmeco First Class machines FC1, FC2 and FC3 with the Millennium electronic board, per manual 344PEL0101. It is not present on the First Class Millennium Basic.

Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.

What you may notice

• The board blinks and ALARM DATE shows after pressing MENU
• The machine otherwise freezes normally
• A scheduled function runs at the wrong time

Possible causes

Listed in Elmeco's documentation

• Date setting problem found by the electronic board

Other likely causes — what usually sits behind ALARM DATE on this control. A technician confirms which one it is before any part is replaced.

• Date never set after the board was replaced or reset
• Long power loss that cleared the stored date
• Date changed accidentally while moving through the menu

Safe checks before calling for service

How a technician diagnoses ALARM DATE

1. Confirm ALARM DATE and the board version.
2. Read the board's current date and compare it with the actual date.
3. Adjust the date with the programmer module as the manual directs.
4. Check the other stored settings for changes after a power loss.
5. Restart the machine and confirm the alarm clears.
6. Look for the reason the date was lost if it returns.

Technical reference

Document

Fetco by Elmeco First Class Millennium slush machine manual (344PEL0101)

Edition

Posted 10-17-16

Models / control

Fetco by Elmeco First Class (FC1, FC2, FC3) with Millennium electronic board

Section

First Class Problem Solving, p. 17 (alarm functions p. 9-13)

Checked

October 2026

We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.