Waring Commercial Blender Repair
We repair Waring Hi-Power Xtreme blenders, including MX1000, MX1200 and MX1500 models with touch or programmable controls, in Miami, Los Angeles, Houston, New York and San Diego. We tell you the price in writing before work starts.
Common Waring blenders problems
In plain words, the way kitchen and laundry staff describe them when they call.
Blender stops during the cycle
Container leaks at the blade
Touch pad does not respond
Motor noise from worn coupling
Waring’s Hi-Power Xtreme line covers the MX1000, MX1050, MX1100, MX1200, MX1300 and MX1500, each with a 64-ounce container and a 3.5 horsepower motor on a 120 volt circuit. The letters at the end of the model number tell you the controls: XTX for a touch pad, XTP for programmable and XTS for a switch. Models ending in EE are 230 volt.
A blender that stops during a cycle has most often reached its motor thermal protection. We ask how long and how heavy the cycle was, then check the vents and the motor. A container that leaks at the blade assembly needs the seal and the assembly inspected, and a touch pad that does not respond needs the pad and its connection tested.
The coupling between the motor and the container is a wear part, and a noisy motor often means it is worn. On a busy bar or smoothie counter, it takes a beating, and so do the container pad and the blade assembly. We replace what is worn and test the machine under load before we leave.
We confirm parts first, give a written price before work begins, and back the repair with a 30-day warranty on our work.
Commercial Blender
Every maker we repair in this category, with general problems and care.
Open the categoryWaring blenders lines we service
Current and older lines with their model numbers.
Why does my Waring blender shut off in the middle of a smoothie?
Motor thermal protection has probably opened after long or heavy use. We check the vents, the motor and the controls, and give you a written price if a part is needed.
Why is my Waring Xtreme blender so loud?
A worn drive coupling is a common cause. We inspect the coupling and the blade assembly and tell you the price in writing before replacing parts.
Do you repair Waring blenders with the programmable XTP controls?
Yes. We service XTX, XTP and XTS models, including the EE versions on 230 volts. We bring the parts that fit your model and put the price in writing first.
Other Waring equipment we repair
Other blenders makers we repair
Book Waring blenders repair
Tell us the maker, the model number from the data plate and what the unit is doing. We confirm a three-hour arrival window and give you a written price before any work starts.