Eversys Coffee Machine Error Code S-014: Rinse Necessary

What does Eversys error code S-014 mean?

After start-up or a long idle period the Cameo wants a rinse before it heats the boiler. The control holds heating back until someone presses the rinse key, so it displays S-014 and waits. This is an operator step, not a sign that anything has broken, and staff usually clear it in under a minute. The rinse flushes the water paths and confirms the machine is ready to brew. If the rinse is interrupted, for example by pressing other keys partway through, the control may not count it, and the message stays. Water supply matters as well: if the tap is closed or flow is poor, the rinse cannot finish. A rinse that completes normally and still leaves S-014 on the display is the unusual case, and it suggests the control is not registering the completed cycle. The message does not point to a part, and a technician would confirm the rinse runs from start to end before looking further. The display text is S-014.

Affected models and control systems

This applies to the Eversys Cameo with S-xxx stop messages. The related cleaning prompt is S-017, which uses a different key press.

Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.

What you may notice

• Display shows a stop message at start-up
• Boiler does not begin heating
• Drinks are not available
• Message remains if the rinse is interrupted

Possible causes

Listed in Eversys's documentation

• Machine idle long enough to need a rinse before heating
• Rinse not yet run since start-up
• Rinse interrupted before it completed
• Water supply closed during the rinse

Other likely causes — what usually sits behind error code S-014 on this control. A technician confirms which one it is before any part is replaced.

• A rinse key that responds only to some presses after the screen has been wiped wet
• A rinse that starts and stops early because of low water flow

Safe checks before calling for service

How a technician diagnoses error code S-014

1. Run the rinse and watch the whole cycle from start to finish.
2. Verify water flow during the rinse.
3. Check that the rinse key on the display responds.
4. Check the water inlet valve and flow meter if the rinse stops early.
5. Check the control's behavior with a completed rinse and replace the display or board only after the test.

Technical reference

Document

Eversys eSupport: Operator stop messages for Cameo (S-XXX)

Models / control

Cameo (S-xxx stop messages)

Section

Web page table of S-numbers, Infos messages and Explanations / Remedies (no page numbers)

Checked

October 2026

We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.