UniMac Pocket Hardmount Washer-Extractors UWL, UWN and UWU
Current and older. 28 model numbers in this series.
Model numbers in this series
Find yours on the data plate. Letters after the base number usually mark the voltage, finish or door and do not change the repair.
- UWL035K12
- UWL035K1L
- UWL035K1M
- UWL060K12
- UWL060K1L
- UWL060K1M
- UWL065K1L
- UWL080K1M
- UWL100K1M
- UWL125K1M
- UWN035K12
- UWN035K1L
- UWN035K1M
- UWN060K12
- UWN060K1L
- UWN060K1M
- UWN080K1M
- UWN100K1M
- UWN125K1M
- UWU035K12
- UWU035K1L
- UWU035K1M
- UWU060K12
- UWU060K1L
- UWU060K1M
- UWU080K1M
- UWU100K1M
- UWU125K1M
Repairs this series usually needs
- Fill alarm when the water level is not reached
- Door lock error on the pocket door
- Slow drain or a drain alarm
- Unbalance error on a rigid mount
- Drive error that stops the cylinder
These 28 numbers cover the UWL, UWN and UWU pocket hardmount washer-extractors in the K1 version, such as UWL060K1M and UWU125K1M. The digits in the middle give the capacity in pounds, from 35 to 125, so UWN080K1M is an 80 lb machine.
A pocket hardmount sits on a rigid mount and spins hard, so the load balance and the mount matter. Our checks start with the error on the control, then the door lock, then the water in and out. An unbalance error on a rigid machine leads us to look at the load, the sensing and the mounting bolts before the drive.
These washers are in hotels, laundries and care facilities, and older units are plentiful. We repair them with the cost agreed on paper beforehand, and we tell you where a repair stops making sense.
About this series
- Pocket hardmount washer-extractors from 35 to 125 lb
- Front-end control with an output board
- Prefixes UWL, UWN and UWU
- K1 models in the PHM1263R family
UniMac industrial laundry codes
Other UniMac industrial laundry series
What size is a UWL060K1M?
The digits after the prefix give the capacity in pounds, so it is a 60 lb pocket hardmount washer-extractor. The data plate carries the full number we use to match parts.
Why does the washer stop with an unbalance error?
On a rigid mount the machine is sensitive to the load and to the mounting. We check the load, the sensing and the mounting bolts, then the drive, because a loose bolt can look like a control problem.
Do you repair older pocket hardmount washers?
Yes. We service older pocket hardmounts that are still in use, confirm parts for the K1 model number first, and weigh the cost of a repair against the remaining life of the machine with you.
Book repair for your UniMac Pocket Hardmount Washer-Extractors UWL, UWN and UWU
Tell us the maker, the model number from the data plate and what the unit is doing. We confirm a three-hour arrival window and give you a written price before any work starts.