Eversys Coffee Machine Error Code W-085: Right Bean Hopper Low
W-085 means the right bean hopper is almost empty. Refill the right bean hopper, as the maker says.
Low: a refill reminder; the machine keeps running.
- Code
- W-085
- Maker
- Eversys
- Equipment
- Super-automatic coffee
- Applies to
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
What does Eversys error code W-085 mean?
Each bean hopper on the Cameo has a light barrier set at the level where beans are getting low. When the right hopper's light barrier no longer detects beans, the control shows "Level of bean hopper right too low." as W-085. The maker's table states that the light barrier of the bean level control has not detected beans in the right hopper and lists one remedy: refill the hopper. The warning is an early notice, so the machine keeps working for some drinks. It is the right-hand twin of W-084. If the beans run out entirely, S-010 or S-012 follows and stops the right-side products. Acting on it early avoids a brew that has to be stopped halfway, with the cup already under the outlet.
Affected models and control systems
Eversys Cameo range (Cameo/Core, Classic, ST and in-box versions), as covered by the maker's e'Support table of W-number warning messages.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- W-085 on the display
- The right bean hopper is nearly empty
- Drinks that use the right hopper may stop soon
Possible causes
Likely causes — what usually sits behind error code W-085 on this control. A technician confirms which one it is before any part is replaced.
- The light barrier in the right bean hopper does not detect beans
- A right hopper that is used less often and was not checked at opening
- Beans bridged above the sensor so the barrier sees an empty space
- A dirty light barrier lens on the right hopper
Safe checks before calling for service
- Refill the right bean hopper with the correct beans.
- Check the hopper is seated and the lock is closed.
- Make a right-side drink and see the warning clear.
- If the hopper is full and it stays, report which side.
How a technician diagnoses error code W-085
- Confirm the hopper level and the bean type loaded.
- Clean the lens and clear any bridged beans.
- Read the light barrier input on the control board.
- Replace the sensor only after cleaning and the signal test.
- The sensor signal is read on the live control board.
- If beans bridge repeatedly, the hopper or grinder feed needs a technician's inspection.
How error code W-085 differs from similar codes
W-084 is the left-hand version; S-035 is the stop message for the right side.
Technical reference
- Document
- Operator warning messages for Cameo (W-XXX)
- Models / control
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
- Section
- Web page table of W-numbers, Infos messages and Explanations / Remedies (no page numbers)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Eversys super-automatic coffee error codes
Is this different from W-084?
Only in which hopper it names. W-085 is the right one.
Can I keep making drinks?
For now, yes. The warning is an early notice, not a stop.
Why does it show when the hopper has beans?
The sensor may be blocked or dirty. Report it if refilling does not clear the warning.
Need help with Eversys error code W-085?
A technician confirms the cause on site and gives you the price in writing before any work starts.