Eversys Coffee Machine Error Code S-013: Coffee Quantity Too High
S-013 means the last coffee product used more coffee quantity than allowed. The maker's table gives no action, so note which product it was and have a technician check the settings.
Medium: a stop message with no listed operator action; drinks may be held.
- Code
- S-013
- Maker
- Eversys
- Equipment
- Super-automatic coffee
- Applies to
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
What does Eversys error code S-013 mean?
The Cameo limits how much ground coffee a single drink may use. If the last product went over that limit, the control shows "Coffee quantity too high (last product)" as S-013. The maker's table repeats that the last coffee product used more coffee quantity than allowed, with no cause and no action. It could relate to the grinder setting or the product recipe, but the table does not say, so treat those only as likely. The message appears in the stop list, so the machine may hold drinks until it is cleared. Because the table lists nothing to do, the useful step is to record which product triggered it. The table does not say what limit applies or how it is set, so the number cannot be quoted here.
Affected models and control systems
Eversys Cameo range (Cameo/Core, Classic, ST and in-box versions), as covered by the maker's e'Support table of S-number stop messages.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- S-013 after a coffee drink
- A drink may have been too strong or overfilled
- The machine holds further drinks
Possible causes
Likely causes — what usually sits behind error code S-013 on this control. A technician confirms which one it is before any part is replaced.
- A grinder set coarser or finer than the recipe expects, so the dose runs high
- A recipe edited with an oversize coffee quantity
- A dose sensor that over-reads
Safe checks before calling for service
- Note which coffee product ran just before S-013.
- Try the product again once.
- Do not change grinder or recipe settings yourself.
- Report the product and cup quality.
How a technician diagnoses error code S-013
- Read the recipe quantity for the product.
- Weigh the dose from the grinder.
- Check the grinder setting and the dose sensor.
- Correct the recipe or grinder.
- The grinder and recipe live in protected service settings.
- A dose that is wrong needs weighing and adjustment by a technician.
How error code S-013 differs from similar codes
This concerns quantity, unlike S-010 to S-012, which report no coffee at all.
Technical reference
- Document
- Operator stop messages for Cameo (S-XXX)
- Models / control
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
- Section
- Web page table of S-numbers, Infos messages and Explanations / Remedies (no page numbers)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Eversys super-automatic coffee error codes
Is the machine broken?
The table does not say. It reports a quantity over the limit.
Can I make another drink?
The table gives no instruction, so try once and report if it repeats.
Which product caused it?
The message refers to the last product, so note it.
Need help with Eversys error code S-013?
A technician confirms the cause on site and gives you the price in writing before any work starts.