Eversys Coffee Machine Error Code S-010: Right Bean Hopper Empty
S-010 means no coffee powder reached the chamber because the right bean hopper is empty or locked. Refill or unlock the right bean hopper.
Medium: right-side coffee cannot be made until beans reach the chamber.
- Code
- S-010
- Maker
- Eversys
- Equipment
- Super-automatic coffee
- Applies to
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
What does Eversys error code S-010 mean?
When the Cameo makes a coffee, the brewing module expects ground coffee to arrive in the chamber. If none arrives from the right side, the control stops and shows "Bean hopper right is empty or locked." as S-010. The maker's table says the brewing module has detected no coffee powder in the chamber, and that the right bean hopper has to be refilled or unlocked. It gives two causes in effect: the hopper is empty, or its lock is closed. It is a stronger message than the W-085 low-level warning, since the machine has actually tried to brew without coffee. Fix the hopper and the machine can try again. The message is specific to the right side, so products from the left hopper are not described as affected.
Affected models and control systems
Eversys Cameo range (Cameo/Core, Classic, ST and in-box versions), as covered by the maker's e'Support table of S-number stop messages.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- S-010 after a right-side drink
- No coffee in the chamber
- The right hopper looks empty or its slide is closed
Possible causes
Likely causes — what usually sits behind error code S-010 on this control. A technician confirms which one it is before any part is replaced.
- Right bean hopper empty
- Right bean hopper locked
- A hopper shutter left closed after cleaning
- Beans bridged above the grinder so none fall
- A grinder on the right side that has stopped turning
Safe checks before calling for service
- Look at the right bean hopper and refill it if empty.
- Open the lock or slide, if there is one.
- Try the drink again.
- If beans are there and unlocked but S-010 returns, tell the technician.
How a technician diagnoses error code S-010
- Check the hopper, shutter and bean flow.
- Run the grinder and watch the output.
- Test the grinder motor and supply.
- Replace the grinder motor only after the supply checks.
- Grinders are driven from the machine's live supply and have exposed blades.
- Clearing a stuck grinder means taking the hopper unit apart.
How error code S-010 differs from similar codes
S-011 and S-012 cover the left hopper and the unspecified hopper; W-085 is the earlier low-level warning.
Technical reference
- Document
- Operator stop messages for Cameo (S-XXX)
- Models / control
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
- Section
- Web page table of S-numbers, Infos messages and Explanations / Remedies (no page numbers)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Eversys super-automatic coffee error codes
Is it different from W-085?
Yes. W-085 is an early warning. S-010 means no coffee reached the chamber.
What does locked mean?
The table says the hopper must be refilled or unlocked, so a closed lock stops the beans.
Beans are in the hopper. Why?
They may be bridged or the grinder may not be turning.
Need help with Eversys error code S-010?
A technician confirms the cause on site and gives you the price in writing before any work starts.