Eversys Coffee Machine Error Code W-008: Start or Postpone Cleaning
W-008 is an operator prompt from the control asking whether to start the scheduled cleaning now or postpone it. Press Continue to begin, or Cancel in the upper right corner to do it later.
Low: an operator prompt; the machine keeps running if the cleaning is postponed.
- Code
- W-008
- Maker
- Eversys
- Equipment
- Super-automatic coffee
- Applies to
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
What does Eversys error code W-008 mean?
On the Cameo range the control keeps a cleaning schedule and, when the cleaning comes due, it puts up a W-008 warning with the display text "Press". It is a question, not a breakdown. Pressing Continue starts the cleaning now. Pressing Cancel in the upper right corner of the screen postpones it, and the machine goes on making drinks for the time being. The maker's table also says that the cleaning itself is started by pressing and holding the rinse key for two seconds. The table gives no cause beyond the schedule and lists no failed part. Because the prompt only reflects a due cleaning, postponing it does not remove the requirement. The control will ask again, and the maker's table does not say how many times a cleaning can be put off.
Affected models and control systems
Eversys Cameo range (Cameo/Core, Classic, ST and in-box versions), as covered by the maker's e'Support table of W-number warning messages.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- A W-008 message with the word Press on the screen
- Continue and Cancel choices on the display
- The prompt returns after being postponed
Possible causes
Likely causes — what usually sits behind error code W-008 on this control. A technician confirms which one it is before any part is replaced.
- Scheduled cleaning is due and the control is asking when to run it
- A cleaning that was postponed earlier and has come due again
- A shift change at which the operator keeps pressing Cancel to keep serving
Safe checks before calling for service
- Decide whether the machine can be out of service for the cleaning now.
- To start it, press Continue, then press and hold the rinse key for two seconds as the table directs.
- To delay it, press Cancel in the upper right corner.
- Note how often the prompt returned in a day if you call for service.
How a technician diagnoses error code W-008
- Check the cleaning schedule settings on the machine against the shop's hours.
- Confirm the cleaning ran to the end the last time, with chemicals and ball dispenser stocked.
- Verify the prompt clears after a completed cleaning.
- Review whether the interval was set sensibly for the volume served.
- Changing the cleaning schedule means working in the machine's service settings, which operators should not alter.
- If the prompt keeps returning after a full cleaning, the machine's cleaning records need review by a technician.
How error code W-008 differs from similar codes
This is a prompt, unlike the S-series stop messages that block drinks until the operator acts.
Technical reference
- Document
- Operator warning messages for Cameo (W-XXX)
- Models / control
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
- Section
- Web page table of W-numbers, Infos messages and Explanations / Remedies (no page numbers)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Eversys super-automatic coffee error codes
Can I serve drinks with W-008 showing?
Yes, if you press Cancel to postpone. The cleaning is still due and the prompt will return.
Will it go away by itself?
Not for good. It comes back until the cleaning has been completed.
Is W-008 a breakdown?
No. The table describes it as a prompt to start the cleaning now or later.
Need help with Eversys error code W-008?
A technician confirms the cause on site and gives you the price in writing before any work starts.