Eversys Coffee Machine Error Code W-060: Milk Unit Not Connected
W-060 means the milk unit is not detected by the control. Check that the milk unit is seated and its connector is in place, then call a technician if the warning stays.
Medium: milk drinks cannot be made until the unit is detected.
- Code
- W-060
- Maker
- Eversys
- Equipment
- Super-automatic coffee
- Applies to
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
What does Eversys error code W-060 mean?
The Cameo control checks for the milk unit before it makes a milk product. If it cannot detect the unit, it shows "Milk unit not connected." as W-060. The maker's table gives only that meaning, with no cause and no action. A unit that is not seated or whose connector has come loose would show this way, as would a detection problem inside the unit itself, but the table does not say which applies. This W-060 is a warning on the screen. A separate S-032 stop message uses the same words and goes further by switching off the water pump. Until the unit is detected again, milk drinks cannot be made. If the unit is plainly in place and the warning stays, the connection or the detection signal is the next thing a technician would test.
Affected models and control systems
Eversys Cameo range (Cameo/Core, Classic, ST and in-box versions), as covered by the maker's e'Support table of W-number warning messages.
Code numbers and their meaning can change between control generations. We match the full model and control before acting on a code.
What you may notice
- W-060 with a milk drink selected
- The milk unit looks seated but is not recognized
- Coffee-only drinks still work
Possible causes
Likely causes — what usually sits behind error code W-060 on this control. A technician confirms which one it is before any part is replaced.
- A milk unit connector that is not pushed fully home
- A damaged cable or contact pins at the milk unit
- A milk unit detection input that has stopped reading
Safe checks before calling for service
- Turn off the milk drink selection and serve coffee-only drinks.
- Check that the milk unit is pushed fully into place.
- Look for milk or water on the connector and wipe the outside dry.
- If W-060 remains, note whether S-032 also appears and report it.
How a technician diagnoses error code W-060
- Check that the milk unit sits correctly and its connector is clean and undamaged.
- Test the connector pins and cable for continuity.
- Verify the control board reads the unit's detection signal.
- Swap in a known-good unit to separate the unit from the board.
- The connector joins to the control board, which carries live supply voltage.
- Telling a bad unit from a bad board needs a known-good part and meter testing.
How error code W-060 differs from similar codes
S-032 uses the same words but is a stop message that also switches off the water pump, while W-060 is a warning.
Technical reference
- Document
- Operator warning messages for Cameo (W-XXX)
- Models / control
- Eversys Cameo range (Cameo/Core, Classic, ST, in-box), e'Support article
- Section
- Web page table of W-numbers, Infos messages and Explanations / Remedies (no page numbers)
- Checked
- October 2026
We use the maker's document to read the code and do not reproduce it. Always confirm the complete model and control before applying these steps.
Related Eversys super-automatic coffee error codes
Is W-060 the same as S-032?
They share the same wording. S-032 is the stop message, and it also switches off the water pump.
Can I still make coffee?
The table does not say. Coffee-only drinks do not need the milk unit, so they may still work.
What should I check first?
That the milk unit is fully seated. The table gives no action, so this is the practical first look.
Need help with Eversys error code W-060?
A technician confirms the cause on site and gives you the price in writing before any work starts.