Hobart Food Processor Repair
We repair Hobart continuous-feed food processors, the floor-model FP300i and FP400i, and the FP41 and HCM bowl cutters in Miami, Los Angeles, Houston, New York and San Diego. We confirm the model first so the right parts come with us.
Common Hobart food processors problems
In plain words, the way kitchen and laundry staff describe them when they call.
Motor will not start
Lid or pusher not seated
Ragged cuts on vegetables
Motor trips on heavy product
Water leaking at the shaft
Vibration or belt noise
Hobart’s countertop continuous-feed processors are the FP100, FP150, FP250 and FP350, and the floor models are the FP300i and FP400i. For bowl work there are the FP41 processor and the HCM61 and HCM62 cutter mixers. They share the same basic safety design: nothing should turn unless the lid and pusher are locked in place.
A processor that will not start sends us first to the interlock, the lid and the pusher seating. If they are fine, we move on to the switch and the start circuit. When the motor trips on heavy product, we look at how the machine is being loaded and test the overload before blaming the motor.
Poor cut quality is most often a dull or wrong disc or blade, and we help you pick the right one. Leaks at the seal or shaft are a wear problem that worsens with daily washdowns, and noise or vibration points to bearings or a belt. Older processors are worth repairing when the base is sound, and we say so plainly when it is not. We price the repair in writing and give a 30-day warranty on our work.
Commercial Food Processor
Every maker we repair in this category, with general problems and care.
Open the categoryHobart food processors lines we service
Current and older lines with their model numbers.
Why will my Hobart food processor not start?
The lid or pusher is usually not locked in place, so the interlock stays open. We check the interlock, the switch and the start circuit, and quote the price in writing first.
Do you repair the Hobart FP41 and HCM cutter mixers?
Yes. We service the FP41, HCM61 and HCM62 along with the continuous-feed FP models. Tell us the model and we plan the visit around it.
Why does water leak from under my processor bowl?
A worn shaft seal or bowl seal is the usual cause. We confirm which seal it is, give you a written price, and check the shaft for wear before reassembling.
Other Hobart equipment we repair
Hobart dish machines4 series · 15 codes→
Hobart glasswashersService and repair→
Hobart conveyor dish machines1 series→
Hobart pot & pan washers1 series→
Hobart booster heatersService and repair→
Hobart mixers6 series · 11 codes→
Hobart slicers3 series→
Hobart grinders2 series→Other food processors makers we repair
Book Hobart food processors repair
Tell us the maker, the model number from the data plate and what the unit is doing. We confirm a three-hour arrival window and give you a written price before any work starts.