Booking today · Miami, Los Angeles, Houston, New York and San Diego · three-hour arrival windows Independent commercial equipment repair · Every maker on this site Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(844) 393-0816 Schedule a Visit
Model series · Beverage-Air · Reach-in refrigerators

Beverage-Air RB Bottom-Mount Refrigerators

Current line. 15 model numbers in this series.

01Model numbers

Model numbers in this series

Find yours on the data plate. Letters after the base number usually mark the voltage, finish or door and do not change the repair.

  • RB12HC-1S
  • RB19HC-1G
  • RB19HC-1S
  • RB23HC-1G
  • RB23HC-1S
  • RB27HC-1G
  • RB27HC-1S
  • RB35HC-1G
  • RB35HC-1S
  • RB44HC-1G
  • RB44HC-1S
  • RB49HC-1G
  • RB49HC-1S
  • RB72HC-1G
  • RB72HC-1S

Repairs this series usually needs

  1. Condenser blocked by floor dust and lint
  2. Hi alarm from poor airflow at the base
  3. Door gasket wear
  4. Sensor codes on the display
  5. Water in the drain pan

The RB is a Beverage-Air bottom-mount reach-in, with its refrigeration compartment under the food space. Plate numbers such as RB12HC-1S, RB19HC-1G and RB19HC-1S give the width and door type. Fifteen numbers are listed for the line.

Because the condenser sits near the floor, it draws dust, flour and mop-water mist straight into the fins. A bottom-mount box that runs warm in the afternoon is often just short of air. We clean the coil and clear the space around the base first, then check the gaskets, the fans and the control. The drain pan sits low as well, so we look at it for overflow.

If the cabinet sits tight against a wall, we tell you how much clearance it needs.

About this series

  • Bottom-mount reach-in refrigerators
  • Models such as RB12HC-1S and RB19HC-1G
  • Danfoss or Eliwell electronic controller, depending on the build
  • Compressor and condenser below the food compartment
FAQBeverage-Air RB Bottom-Mount Refrigerators questions
Why does my RB warm up late in the day?

By afternoon the kitchen is hot and the floor-level condenser is loaded with dust. The compressor then cannot reject heat fast enough. Cleaning the coil usually brings the cabinet back.

Can I mop around the base?

Yes, but keep water out of the base openings and avoid spraying the condenser. Moisture and dust together form a paste that clogs the fins and is hard to clean.

What does an E01 mean on an RB?

On a Danfoss control it means sensor S1 is not reporting. The cabinet may keep cooling in a fallback mode, but we test the sensor and its wiring soon.

Book a visit

Book repair for your Beverage-Air RB Bottom-Mount Refrigerators

Tell us the maker, the model number from the data plate and what the unit is doing. We confirm a three-hour arrival window and give you a written price before any work starts.

☎ Call our office ▤ Schedule a Visit